Measures voltage range up to 1000 V AC and 1200 V DC.

• Rugged and reliable two-pole voltage tester
• Voltage test up to 1000 V AC / 1200 V DC
• Coloured LED display to make voltage levels visible
• Automatic AC/DC voltage detection with polarity indication
• Switchable load a 10mA or 30mA RCD trip test with two push buttons
• Automatic continuity test with visual LED indicator
• Low resistance indication to check the wiring in the contactor and relay application without the influence of the coils
• Single pole test to check phase polarity
• Two pole phase rotation indication
• Robust, double-insulated cable with wear indication
• Backlight and torchlight
• Audible indication when detected voltages are above 50V AC and 12V DC
• Resistance measurement to 1999 ohms
• IP64 splash and dustproof

Built according to the following standards:

• IEC 61243-3:2014
• EN 61243-3:2014
• DIN VDE 0682-401:2015

Requires 2 x AAA batteries (not included)

The post Voltage & Continuity Tester – 1200V appeared first on EINTAC.

Key Features

• CAT IV, rugged and reliable with IP67 waterproofing
• Drop-proof to 2m (6.5ft)
• 6000 count LCD display
• True RMS
• AC/DC voltage measurements to 1000V
• AC/DC current measurements to 10A
• Resistance measurements to 60MΩ
• Capacitance testing to 99.99μF
• Frequency (electrical) testing from 0.001 Hz to 10 MHz
• Frequency (electronic) testing from 0.01 Hz to 1 kHz
• Duty cycle from 0.1 to 99.9%
• Temperature testing from -4 to 1400°F (-20 to 760°C)
• Operating temperature from 0°C to 50°C (32°F to 122°F)
• Continuity/diode testing
• 1000V input protection on all functions
• Data hold and relative hold
• Double-moulded, ultra-tough housing
• Backlight and Auto Power Off
• Dimensions: 183 mm × 83 mm × 55 mm (7.1 in × 3.2 in × 2.1 in)
• Weight: 365 g (12.9 oz)

What’s Included?

• Heavy Duty Industrial Multimeter
• Double Moulded Test Leads
• Magnetic Hanging Strap
• Type K Bead Wire Temperature Probes
• Carrying Case
• 9V Battery

Please note: a calibration is NOT supplied as standard. However, this can be purchased at the time of ordering for an additional cost. Please enquire with us for more details.

The post Premium Heavy Duty Industrial Multimeter appeared first on EINTAC.

The Knightsbridge Cat III 2 Pole Voltage Tester is manufactured to the highest standard.

• AC and DC Voltage test from 12-690V on an LCD display
• Rx LED for continuity test indication
• Polarity indication
• Single-phase pole test
• Phase rotation test with R/L LEDs displayed
• High Voltage Indication
• Frequency Range: 12~60Hz

Requires 2 x AAA batteries (not included)

Please note, the maximum voltage for this product is 690V. Usage of voltages above this figure can cause damage to the Voltage and Continuity Tester. For higher voltages please use the Voltage & Continuity Tester – 1200V.

The post Voltage & Continuity Tester – 690V appeared first on EINTAC.